Larger Image
Maximum Motorsports Stainless Steel braided, PTFE-lined Front Brake Hose Kit.
Designed for SN95 brake caliper swaps. Connects OEM front calipers from 1994-2004 Mustangs to 1979-1981 Mustangs originally equipped with 9.3" front brake rotors. SN95 spindles and other parts are required to complete this swap.
Fits
- SN95 front calipers swapped to a 1979-1981 Mustang having 3/8"-24 tube nuts on the front brake hard lines. Mustangs with 3/8"-24 tube nuts were those originally fitted with a 2.3L normally-aspirated engine or 2.8L engine. These Mustangs were originally equipped with extremely small front brake rotors, only 9.3" in diameter.
- Most 2000 Cobra R Brembo calipers, the later production calipers that attach the brake hose to the caliper with a banjo fitting and a 10mm fluid bolt.
Does NOT fit
- 1979-1981 Mustangs originally fitted with a V8 or 2.3L turbocharged engine. These Mustangs were originally equipped with front brake hard line fittings on the chassis with tube nuts having 7/16"-24 threads. These Mustangs were originally equipped with 10" diameter front brake rotors. Use the MMBK8F hose kit for these cars.
- Early production 2000 Cobra R Brembo calipers. These attach the brake hose to the caliper with a JIC fitting connected to a pipe fitting in the caliper.
Note
Minor modifications to the chassis hose-mounting tabs may be required.
PTFE-lined, braided stainless steel hoses improve performance over stock rubber hoses by providing
- A firmer brake pedal
- Quicker braking response
- Easier brake modulation
This kit includes
- Two brake hoses with 3/8"-24 threads for the hardline tube-nut connection
- One pair of coarse-thread fluid bolts (M10 x 1.5)
- One pair of fine-thread fluid bolts (M10 x 1.0)
- Four copper sealing washers
- Complete installation instructions
MM also carries high performance brake fluid.
For more details and technical information, scroll down.
Features of MM brake hoses
- The ability of the hose end to swivel at the chassis prior to tightening. This allows perfect alignment between the chassis hose-mounting tab and the caliper's banjo fitting.
- A brake fluid-resistant clear urethane covering helps protect the stainless steel braid.
- DOT compliant
Ford used both coarse-thread and fine-thread fluid bolts during the 1994-04 production years. We include both types of fluid bolts to ensure that you will have what is needed for your Mustang.
Braided stainless steel hoses are considered a safety requirement for any car that is raced. The high heat generated during track use has been known to cause failure of the stock rubber hoses.
Maximum Motorsports was the first with direct replacement stainless steel brake hoses for Mustangs, offering them since 1993.