• Direct replacement dust boot for SN95 Mustang ball joints. This boot correctly fits the Mustang ball joint, unlike universal urethane boots.
• Fits ALL MM Front Control Arms for Fox and SN95 Mustangs.

• 1994-04 SN95 Mustang ball joint.
• MM Front Control Arms for Fox Mustangs.
• MM Front Control Arms for SN95 Mustangs.

Fits

• 1994-04 SN95 Mustang ball joint.
• MM Front Control Arms for Fox Mustangs.
• MM Front Control Arms for SN95 Mustangs.

Note: Does NOT include retaining circlips; re-use yours.

Does NOT fit

• Fox Mustang (1979-1993) ball joint.

Do you provide installation instructions?
No. This part is installed in the same manner as a regular service replacement part. If you do not know how to install it, see a professional.

We will give you some hints; see the Instructions tab.

• This part is installed in the same manner as a regular service replacement part.
• If you do not know how to install it, see a professional.
• Improper installation may lead to a failure causing serious damage.

We will give you some hints; even some professionals miss these.

• OEM control arms: After removing the old ball joint, take steps to slightly reduce the diameter of the ball joint hole in the stamped steel control arm. All it needs is a few thousandths of an inch to ensure a tight press fit.
• MM control arms: use a sleeve-retaining (also called bearing-retaining) compound to ensure retention in the machined receiver tube. A commonly available brand is called "green Loctite."
• NEVER tack-weld the ball joint to the control arm. Doing so will destroy the low-friction lining.